Eclipse Scientific has introduced a practical solution for performing crack detection, and monitoring inspection of bolts. The ESBoltScanner allows you to determine the extent of corrosion and to identify cracking without removing the bolt.

The ESBoltScanner inspection system has an upper probe housing which clamps the probe into place and allows it to be adjusted up and down to reach studs above or below the nut surface. It can also be adjusted back and forth on the bolt head surface to achieve optimum scanning position. Adjustable spring mounting ensures that the probe contacts the bolt with an even force over the surface, and protective wear-face plates ensure that the probe does not suffer abrasion damage.

Features

Fast and easy to use
Displays cracking and corrosion
Defect images are clear and easy to interpret
Three sizes available
Fastens directly to thread, bolt head or nut

Productivity Features

On-site start-up support
Procedures & techniques
Bolt inspection training
Expert personnel to perform inspections
Calibration blocks


WEBSCAN-A0 Fits 1/2" (M12) to 1" (M27) Bolts	WEBSCAN-A1 Fits 1" (M27) to 1 1/2" (M39) Bolts	WEBSCAN-A3 Fits 1 3/8" (M35) to 2" (M52) Bolts
Special order housings can be made to accommodate any bolt or probe. A complete solution, including procedure, technique and step-by-step instructions, is also available to ensure that the job is completed in the shortest possible time and with the greatest amount of accuracy and repeatability.

Gallery

Capabilities
Specifications
Accessories

The ESBoltScanner can scan bolt sizes ranging from M12 to M105 by selecting from the range of clamping hubs. Each clamping hub is marked with a size that represents the maximum width across flats (WF) of the size of bolt head or nut that will fit the hub. The minimum diameter of bolt or stud is determined by the aperture opening of the clamping hub probe size, which is marked on the top of the rotating scanning head.
WEBSCAN-A014 Max WF: 1 1/4” (32 mm) Fits bolt sizes: Min: 1/2” (M12) Max: 3/4” (M20) Detection Depth: 4” WEBSCAN- A0 Max WF=1 5/8” (42 mm) Fits bolt sizes: Min. 3/4” (M20) Max. 1” (M27) Detection Depth: 4” WEBSCAN-A1 Max WF=2 3/8” (61 mm) Fits bolt sizes: Min. 1” (M27) Max. 1 1/2” (M39) Detection Depth: 6” WEBSCAN-A3 Max WF=3 1/8” (81 mm) Fits bolt sizes: Min. 1 3/8” (M35) Max. 2” (M52) Detection Depth: 12”